To Next Page

To Previous Page

Setup and Configuration

Tango Series Audio Controllers

 Select Quit to return to the About screen, where another unit can be selected.

 Select Main Keypads to view the software version of the Main Keypads. The following

screen is displayed (FIG. 55):

 “OK” returns you to the About MRC screen.

Program LCD KP

Select Program LCD KP to display the Reprogram LCD Keypad screen (FIG. 56).

This option puts the Controller in the correct mode to allow LCD Keypads to be programmed. The

communication on the I2C bus will be stopped so that the programming of the LCD keypads is not

interrupted.

Once the LCD KP has been programmed, select QUIT to exit the screen. Communication on the I2C bus

will resume.

FIG. 55 MRC Main Keypads

FIG. 56 Reprogram LCD Keypad screen

Other manuals for AMX DAS-T0804-SIG

Questions and Answers:

Need help?

Do you have a question about the AMX DAS-T0804-SIG and is the answer not in the manual?

General