Installation
22
Tango Series Audio Controllers
Programming The MIO R-1 AUDIO Using KeypadBuilder
The MIO R-1 AUDIO comes pre-customized with appropriate labels, which in most cases should not be
changed. However, if in your installation you intend to use the MIO R-1 AUDIO with a NetLinx
Controller and Metreau AxLink keypads (for more than just Audio), you could customize your buttons
in the KeypadBuilder application. The application and documentation are available from
www.amx.com.
There are a select number of Serial Commands the MIO R-1 AUDIO recognizes. For a full list and
descriptions, consult the MIO R-1 AUDIO Operation/Reference Guide.
The Programming Jack is used for communication between the device and KeypadBuilder. The
programming jack uses a three-wire, 2.5 mm stereo jack, you can order the programming cable (FG10-
817) from AMX if you do not currently possess one. While loading your configuration file make sure the
device is situated as such that the batteries will not fall out. The load will fail if your batteries fall out
during the process. The MIO communicates at 115200 baud rate.
Refer to the MIO R-1 AUDIO Operation/Reference Guide for instructions on using the Programming
Jack to load configuration files on the MIO R-1 AUDIO.
Tone Control & SRS Setting
To access the Tone Control and SRS settings, press the TONE button. This enables the Tone Control
Mode with BASS as the first mode selected. There are 3 Tone Control Modes available for adjustment,
and 4 SRS options, as follows:
BASS: Increase / Decrease from -10dB to +10dB (Up/Down NAV buttons)
Treble: Increase / Decrease from -10dB to +10dB (Up/Down NAV buttons)
Balance: Left / Right (Up NAV button = right, Down NAV button = left)
SRS options: BASS Boost, Focus, 3D, WOW
The Source buttons on the Metreau keypad provides visual feedback as to which mode it is currently in.
The following sources will light based on the current mode:
Source 1 = BASS
Source 2 = Treble
Source 3 = Balance
Source 4 = SRS
When first entering Tone Control Mode, BASS mode is active (Source 1 LED is lit). To move from mode
to mode, select the Center NAV button. This saves the setting and moves to the next mode.
Note: While in each of the modes, press and hold the Center NAV button to return to the default for that
mode.
SRS (Bass Boost, Focus, 3D and WOW) Settings
Use the UP Nav button to cycle through the SRS Settings: BASS Boost, Focus, 3D, WOW (in that
order).
Use the Down NAV button to cycle backwards to the previous SRS setting.
Press and hold the Center NAV button to disengage/clear the SRS settings (none of the SRS
modes will be engaged).
Press the Center NAV button to save SRS Mode & exit from Tone Control
set-up.
Only one SRS mode can be engaged per room/zone. Each room/zone, however, can have a different
SRS mode.
To Next Page
Loading...
Need help?
General
