AMX DAS-T0804-SIG User Manual

Setup and Configuration
42
Tango Series Audio Controllers
4. Select Increase and Decrease to adjust the input attenuation for the selected device.
5. Select Exit to adjust the input attenuation for another source:
Adjusting Output Gain
1.
From the MRC Gain/Attenuation Mode screen, select “Output Gain” (FIG. 35):
2. The Output Gain Mode screen is displayed. Select the source to be adjusted for “Output Gain”
(FIG. 36).
3. The following screen is displayed (FIG. 37):
Notes:
 Increasing Output Gain will have the effect of increasing the sound level, while decreasing the
Output Gain will lower the sound level
 Output Gain can be adjusted in increments of 3dB as follows:
0, +3, +6, +9, +12, +15, +18
4. Select “Exit” to set Output Gain for another source.
FIG. 34 Set Input Attenuation for Source # screen
Increasing attenuation will have the effect of dropping the sound level, while
decreasing the attenuation will raise the sound level.
Input Attenuation can be adjusted in increments of 3dB as follows: 0, -3, -6, -9, -12.
FIG. 35 MRC Gain/Attenuation Mode - Output Gain
FIG. 36 Output Gain Mode - Exit
FIG. 37 Set Output Gain for Source # 3

AMX DAS-T0804-SIG Specifications

General

Brand	AMX
Model	DAS-T0804-SIG
Category	Recording Equipment
Language	English