AMX Duet Module Interface Specifications
69
Tango Audio Controllers
AMX Duet Module Interface Specifications
Port Mapping
This module uses multiple virtual devices in order distinguish events for one zone from another or to
distinguish one input source from another.
Input Sources use ports 1 - 8.
Rooms/Zones use ports 1 - 64.
Channels
The UI module controls the Tango Controller via channel events (NetLinx commands pulse, on, and off)
sent to the COMM module. The channels supported by the COMM module are listed below. These
channels are associated with the virtual device(s) and are independent of the channels associated with the
touch panel device. Depending on how the device is programmed each source has it’s own set of
applicable commands/channels (see the Input Source Types section on page 76).
An asterisk ( * ) indicates an extension to the standard API.
Tango Controllers - Port Mapping
Virtual Device Channels Levels Control Feedback
41001:1:0 All All All All
41001:2:0 - 41001:8:0 (inputs) 1,3,9,21,22,23,27,28,
40,44,45,46,47,48,49,
81,82,225,226,255,301,
303
none ?BAND
?XCH
XCH-
BAND-
XCH-
TUNE_MODE-
TUNERPRESETSAVE
41001:2:0 - 41001:64:0 (rooms) 24,25,26,164,
165,166,167,
168,169,196,
199,302,304, 305,306
1, 2,3,4,8 ?INPUT
INPUT-
INPUT-
Tango Controllers - Channels
Channel Description
1 PULSE: Play
3 PULSE: Pause
9 PULSE: Cycle Source Power
21 PULSE: Enter Button
22 PULSE: Next Station Preset
23 PULSE: Previous Station Preset
24 ON: Ramp Volume Up – used for feedback also
OFF: Stop Ramping
25 ON: Ramp Volume Down – use for feedback also
OFF: Stop Ramping
26 PULSE: Cycle Volume Mute
27 PULSE: Set Source Power On
28 PULSE: Set Source Power Off
40 PULSE: Cycle Tuner Band
44 PULSE: Menu Button
45 PULSE: Move Menu Cursor Up
To Next Page
Loading...
Need help?
General
