Installation
14
Tango Series Audio Controllers
Connecting Tango Zone Expanders
Tango Zone Expanders (FIG. 9) are used to expand the number of zones in the system beyond the 8 that
are available using the Tango Controller. Each Tango Zone Expander has the capability of offering either
4 or 8 zones per Zone Expander.
Up to seven Zone Expanders may be used in the system, offering the ability to expand the system to 64
zones. Tango Zone Expanders are available in two variations:
DAS-T0804X-SIG Tango 4-Zone Expander (FG1103-11)
DAS-T0808X-SIG Tango 8-Zone Expander (FG1103-12)
FIG. 10 provides a wiring diagram illustrating the connections between the Tango Audio Controller and
multiple Tango Zone Expanders:
1. Connect the RJ-11 jack labelled "Expansion Out" on the Tango Controller to the RJ-11 jack labelled
"Expansion Port In" on the rear panel of the Zone Expander. This connection provides the Tango
Controller with the ability to control the Zone Expander (see FIG. 10).
FIG. 9 Tango Audio Zone Expander
FIG. 10 Connecting the Tango Controller to Zone Expanders
Tango Audio Controller
Tango Zone Expander 1
Tango Zone Expander 2
To Zones 1-4
To Zones 5-8
To Zones 9-10
To Zones 11-12
To Zones 15-16
To Zones 13-14
From Audio Device (L/R)
To Next Page
Loading...
Need help?
General
