AMX NX-3200 User Manual

Initial Configuration
25
NX-Series Controllers - WebConsole & Programming Guide
Communicating via IP Address
Whether the on-board Master’s IP address was set or obtained via DHCP, use the IP address information from the Network
Addresses dialog to establish communication via the LAN-connected Master.
1. Use NetLinx Studio to obtain the IP address of the NX controller. If you do not have an IP address, follow the steps outlined in
either the Obtaining the NX Controller’s IP Address (using DHCP) section on page 23, or the Assigning a Static IP to the NX
Controller section on page 24.
2. Select Settings > Workspace Communication Settings from the Main menu to open the Workspace Communication Settings
dialog (FIG. 15):
3. Click System Settings to open the Communications Settings dialog. If you do not have a system selected, click the Default
Settings button (FIG. 16).
FIG. 15
NetLinx Studio - Workspace Communication Settings dialog
FIG. 16 NetLinx Studio - Communication Settings dialog (TCP/IP selected)

AMX NX-3200 Specifications

General

Brand	AMX
Model	NX-3200
Category	Controller
Language	English