5-24 Chapter 5: RAID conguration
5.2.6 Checking the drives for data consistency
You can check and verify the accuracy of data redundancy in the selected logical drive.
The utility can automatically detect and/or detect and correct any differences in data
redundancy depending on the selected option in the Objects > Adapter menu.
The Check Consistency command is available only for logical drives included
in a RAID 1 set.
Using the Check Consistency
To check data consistency using the Check Consistency command:
1. From the Management Menu, select Check Consistency, then press
<Enter>.
2. The screen displays the available RAID set(s) and prompts you to select the
logical drive to check. Press the <Spacebar> to select the logical drive from the
Logical Drive selection, then press <F10>.
To Next Page
Loading...
Need help?
General
