Asus P5BV-M - Creating a RAID 0 Set (Stripe)

ASUS P5BV-M 5-31
5.3.1 Creating a RAID 0 set (stripe)
To create a RAID 0 set:
1. From the utility main menu, select 1. Create RAID Volume, then press <Enter>.
This screen appears.
2. Enter a name for the RAID 0 set, then press <Enter>.
3. When the RAID Level item is highlighted, press the up/down arrow key to select
RAID 0(Stripe), then press <Enter>.
4. When the Disks item is highlighted, press <Enter> to select the hard disk drives
to congure as RAID. This SELECT DISKS screen appears.
Intel(R)MatrixStorageManagerOptionROMv5.0.0.1032ICH7RwRAID5
Copyright(C) 2003-05 Intel Corporation. All Rights Reserved.
[ CREATE ARRAY MENU ]
[ DISK/VOLUME INFORMATION ]
Enter a string between 1 and 16 characters in length that can be used
to uniquely identify the RAID volume. This name is case sensitive and
cannot contain special characters.
[↑↓]-Change[TAB]-Next[ESC]-PreviousMenu[Enter]-Select
Name:
RAID Level:
Disks:
StripSize:
Capacity:
Volume0
RAID0(Stripe)
Select Disks
128KB
0.0 GB
Create Volume
[ SELECT DISKS ]
[↑↓]-Previous/Next[SPACE]-Selects[ENTER]-SelectionComplete
PortDriveModelSerial#SizeStatus
0 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
1 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
2 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
3 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
Select 2 to 4 disks to use in creating the volume.
5. Use the up/down arrow key to highlight a drive, then press <Space> to select.
A small triangle marks the selected drive. Press <Enter> after completing your
selection.