Rear cover
Remove the four nuts (7) and lift off the rear cover
(8). Examine the cover for damage or cracks, and
replace if necessary.
Filter cover
Undo the filter cover knob (10) and take off the filter
cover (11).
Lift out the air filter (12) from the filter housing. Ex-
amine the condition of the filter. If it is dirty, it must be
replaced.
Note: Do not use compressed air to clean the air fil-
ter, as it may damage the paper insert.
The air filter should be replaced after 70 hours’ use.
In extremely dirty conditions, e.g. when working with
concrete, the filter should be examined at least twice
a day and cleaned or replaced as required.
Note: A dirty or choked filter will impair the perfor-
mance of the machine and will increase wear in its
internal parts.
Fan cover
Remove the two screws (13) holding the fan cover
(14) and lift off the cover. Examine the cover for
cracks, and replace if necessary.
Starter cover
Remove the three screws (15) and lift off the starter
cover (16).
13
Crowder Supply Co., Inc. • 8495 Roslyn St., Commerce City, CO 80022 • Toll Free: 888-883-5144 • www.CrowderSupply.com
To Next Page
Loading...
Need help?
General
