Set Up Guide
Autronic Programming Software
Computer Requirements
The calibration and data logging software supplied with Autronic SM4 ECU may be used with
computers operating under Windows 95/98/ME/XP or 2000.
Computer Required Hardware
The computer must have the following hardware
• VGA graphics adaptor (or compatible adaptors).
• Minimum of 2MB random accesses memory.
• One serial communication port, or USB port and serial to USB adaptor (Windows
software only).
One 3.5" floppy disk drive.
Installing Autronic Software
Step 1. Start Windows
Step 2. Place floppy disk in A: drive.
Step 3 Click on the “Start” button and then click on “Browse”.
Step 4 Select the A: drive and double click the file on the A drive.
Step 5. Click the OK button.
Step 6. Read the options displayed and click the “Next” buttons to complete the installation.
Step 7. Double click on the icon on the desktop to run the software.
Starting Autronic software
After installing the software, an icon should appear on the desktop. Double click the icon to start
the Autronic software
Double click icon to start Autronic Software
To Next Page
Loading...
Need help?
General