In Fel!Hittar inte referenskälla. below is an example of boost pressure on a high gear is
shown. The boost control has been tuned so the turbo will at most give a boost pressure around
the wanted Boost setpoint, and well within the Over boost margin that otherwise would cause
a boost cut to avoid damaging the engine.
Example log of boost pressure
Next step is to configure the Boost setpoint table. The procedure is the same for all of the
three available Boost setpoint tables. Even if you don’t use more than one table, it is good
practice to setup the other two tables with some safe values.
To Next Page
Loading...
Need help?
General