I/P HSI
High speed inputs.
Setup
• Vehicle speed.
• Digital air flow meter
• Variable camshaft input
I/P HSI 1&2
Input HSI 1
Select functions
Disable=None
Cam 1=(Camshaft position 1). For camshaft control, need to setup
"Variable cam setup" and "GPC"
Trigger edge
Pulse trigger edge.
"SUBARU 01..04 pnp"=-ve edge ONLY.
"SM4"
Reluctor sensor type.
Must fit external reluctor interface & MUST select +ve edge.
Hall.
Can be +ve or -ve edge or divide by 8.
NOTE1
External reluctor sensor setup. Sensor polarity must be as follows. On plus
input pin, wave should rise first then fall through trigger point.
NOTE2
Vehicle speed I/Ps, recommended 6 teeth per rev.
HSI scale factor
I scaling factor.
Scales I pulse inputs.
I/P I as
Disabled=(Scale not used)
Cam position=(Set to 1.0000)
Road speed=(Meter/Pulse or Wheel circumference(meters) divided by
number of pulse per rev)
I/P HSI 3
Input slow HSI 3
Select functions
Disable
Vehicle speed (Recommended for vehicle speed I/Ps with <10 pulses/rev)
HIS slow scale
HSI scaling factor.
Scales HSI pulse inputs.
Recommended for vehicle speed I/Ps with <10 pulses/rev
I/P HSI as
To Next Page
Loading...
Need help?
General