149R5905752 /16 DP2K C
Required tools
No tools required.
How to converge
1. Slightly turn the green colored control knob number 4 until the green pattern in the center of the projected
image converges with the blue pattern. Note that a turn of a few degrees corresponds with one full pixel.
Note: When start turning the knob, a little resistance can be felt. This resistance is part of the
internal locking mechanism of the adjustment.
Image 12–9 Clockwise turning will move the line downwards.
2. Slightly turn the green colored control knob number 5 until the green pattern in the lower left of the
projected image converges with the blue pattern.
Image 12–10 Clockwise turning will move the line upwards.
3. Slightly turn the green colored control knob number 6 until the green pattern in the upper right of the
projected image converges with the blue pattern.
Image 12–11 Clockwise turning will move the line upwards.
4. Repeat go to step 2 and go to step 3 until coincidence is obtained of the green pattern in the lower left and
upper right of the projected image.
Convergence
To Next Page
Loading...
Need help?
General
