R5905752 /16 DP2K C48
3. Install the anode wire lug (reference 6) upon the anode socket. Use an 17 mm open-end wrench to hold
the first nut (reference 7) while fastening the lock nut (reference 4) on the rod with a torque of 9 Nm (6,64
lbf*ft) using a torque wrench with 17 mm hexagon socket. Ensure that there is a flat washer (reference 5)
between the lock nut and the wire lug.
Caution: Do not tighten the first nut (reference 1) against the connector housing. There must be
some play (1 mm maximum). This is important to insert the Lamp House smoothly into the
projector.
Image 4–15 Anode lug installation
4. Remove the protective container or unwrap the protective cloth from the xenon lamp.
Warning: Ensure that you wear protective clothing, a full face shield and protective gloves.
Tip: Write down the serial number of the lamp. You will need this while updating the lamp
parameters after installation of the lamp. The serial number of the lamp is engraved in the neck
of the xenon lamp.
5. Gently guide the xenon lamp into position inside the Lamp House as illustrated. Anode socket hanging
vertical down. While inserting the lamp, rotate it slightly, engaging the pins of the cathode adapter in the
foreseen slots. This is to ensure the lamp cathode is completely inserted.
Image 4–16 Lamp bulb installation
Warning: Make sure that the both pins of the cathode adapter are engaged in the foreseen
slots.
Lamp & Lamp House
To Next Page
Loading...
Need help?
General
