Observe checklist
Use the following checklist to
check your motorcycle at regu-
lar intervals.
Requirement
Before every journey:
Check operation of the brake
system.
Check operation of the lighting
and signal system.
Checking clutch function
( 140).
Check tire tread depth
( 143).
Check secure hold of cases
and luggage.
Requirement
At every third refueling stop:
without Dynamic Damping
Control (DDC)
OE
Adjusting spring preload at rear
wheel ( 71).
Adjust compression damping
on front wheel ( 73).
Rebound-stage damping on
front wheel ( 74).
with Dynamic Damping Control
(DDC)
OE
Adjusting spring preload at rear
wheel ( 72).
Adjust spring preload on front
wheel ( 70).
Check engine oil level ( 134).
Check front brake pad thick-
ness ( 136).
Check rear brake pad thickness
( 137).
Checking front brake fluid level
( 138).
Checking rear brake fluid level
( 139).
Checking coolant level
( 141).
Lubricate chain ( 166).
Check chain tension ( 167).
Starting
Starting the engine
Switch on ignition.
Pre-Ride-Check is carried out.
( 83)
ABS self-diagnosis is
performed. ( 84)
ASC self-diagnosis is per-
formed. ( 85)
with Dynamic Traction Control
(DTC)
OE
DTC self-diagnosis is per-
formed. ( 85)
Engage neutral, or pull back
clutch lever if a gear is en-
gaged.
NOTICE
You cannot start the motorcycle
with the side stand extended and
a gear engaged. The engine will
switch itself off if it is started with
the transmission in neutral and
then a gear is engaged before
retracting the side stand.
6
82
z
Riding
To Next Page
Loading...
Need help?
General
