CHANGING THE EMBROIDERY FOOT
B-42
Either embroidery foot “W+” with LED pointer or “W” is included depending on the countries or regions.
The embroidery foot is attached to the machine when purchased, with the connector of the embroidery
foot “W+” with LED pointer unplugged from the machine.
Removing the Embroidery Foot
a
Press the “Needle Position” button to raise
the needle.
b
Press .
* If the message “OK to automatically lower the
presser foot? ” appears on the LCD screen, press OK
to continue.
→ The entire screen becomes white, and all keys and
operation buttons are locked.
c
Raise the presser foot lever.
→ For users of embroidery foot “W”, skip step d and
go to step
e.
d
Unplug the connector of the embroidery
foot “W+” from the jack on the back of the
machine.
e
Use the included screwdriver to loosen the
screw of the embroidery foot, then remove
the embroidery foot.
a Screwdriver
b Embroidery foot
c Embroidery foot screw
→ Remove the embroidery foot.
Attaching the Embroidery Foot
CHANGING THE EMBROIDERY FOOT
• Always press on the screen before changing the embroidery foot. If is not pressed and
the “Start/Stop” button or another button is pressed, the machine will start and may cause injury.
• Only use embroidery feet made for this machine. Using other presser feet may lead to accident or injury.
• Make sure that the embroidery foot is installed
in the correct direction, otherwise the needle
may strike the embroidery foot, breaking the
needle and causing injuries.
To Next Page
Loading...
Need help?
General
