REMOTE FAX OPTIONS
9 - 4
Remote Commands
Follow the commands below to access features remotely. When you call the
FAX/MFC and enter your Remote Retrieval Access Code (1 5 9 ), the system
will signal you with two short beeps to enter a remote command.
Remote Commands Operation Details
95 Changing Fax Forwarding
/Paging setting
1 OFF If you hear one long beep, the change is accepted. If you hear three
short beeps, you cannot change it because the conditions have not
been met (Example: registering paging number). You can register
your fax forwarding number by using 4. FAX FWD NO. (see page
9-5). Once you have registered the number, the FAX/MFC will
change automatically to FAXFWD:ON mode.
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON You can turn FAX STORAGE to ON or OFF.
7 Fax Storage OFF
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to receive stored fax
messages. (See page 9-5.)
3 Erase faxes from the
memory
If you hear one long beep, you can erase fax message(s) from the
memory.
97 Check the Receiving Status
1 FAX You can check whether your FAX/MFC has received any faxes.
If yes, you will hear one long beep. If no, you will hear three short
beeps.
98 Change the Receive Mode
1 TAD: ANSWER MACH. If you hear one long beep, you can change the Receive Mode.
If you hear three short beeps, you cannot change it.
2 FAX/TEL
3.FAX ONLY
90 Exit After a long beep, you can exit Remote Retrieval.
To Next Page
Loading...
Need help?
General
