54
Flash Control from the Camera’s Menu Screen
Flash firing
To perform flash photography, set to [Enable]. To use the flash's AF-
assist beam only, set to [Disable].
E-TTL II flash metering
For normal exposures, set it to [Evaluative]. If [Average] is set, the
flash exposure will be averaged for the entire scene metered by the
camera. Flash exposure compensation may be necessary
depending on the scene. This setting is for advanced users.
Flash synchronization speed in Av mode
You can set the flash synchronization speed when shooting in <f>
aperture-priority AE mode with flash.
Flash mode
You can select the flash mode from [E-TTL II], [Manual flash],
[MULTI flash], [AutoExtFlash], and [Man.ExtFlash] to suit your
desired flash photography.
Shutter sync settings
You can select the flash firing timing/method from [1st curtain], [2nd
curtain], or [High-speed synchronization]. To perform normal flash
photography, set [1st curtain].
Flash exposure compensation
With a similar procedure as exposure compensation, you can adjust
the flash output. The flash exposure compensation amount can be
set up to ±3 stops in 1/3-stop increments.
FEB
You can take three shots while automatically changing the flash
output. The settable range is up to ±3 stops in 1/3-stop increments.
To Next Page
Loading...
Need help?
General
