4
Special Copying and Mail Box Features
Transparency Interleaving 4-19
Transparency Interleaving
When copying onto transparencies loaded into the stack bypass, this mode enables you to
automatically add an interleaving sheet of paper between each sheet of transparency that is output.
The interleaf sheets protect the copied surface of the transparencies. You can also set to copy the
content of the transparencies onto interleaf sheets.
Remark
For information on the modes which cannot be set in
combination with this mode, see "Combination of
Functions Chart(p.9-2)."
Even if an optional finisher is attached, you cannot use
any of the Finishing modes with the Transparency
Interleaving mode.
Only A4 is available for the Transparency Interleaving
mode.
The machine's counter does not count blank interleaf
sheets as copies.
If Tray Designation settings are set only for Copy
Tray-J1, transparencies are output to Tray A. The Tray
Designation settings may vary depending on the
optional output units that are attached to the machine.
For details on the tray designations, see the Reference
Guide.
If You Do Not Want to Print on the Interleaf Sheets:
The [Leave Blank] setting outputs a printed transparency and a blank interleaf sheet alternately.
If You Want to Print on the Interleaf Sheets:
The [Print] setting outputs a printed transparency and a printed interleaf sheet alternately.
Acesst 1.0 6251194
To Next Page
Loading...
Need help?
General
