Canon iR3225 Guide

7
Using the Express Copy Basic Features Screen
Copying Separately-Set Originals (Job Build) 7-53
Copying Separately-Set Originals (Job Build)
For instructions on this procedure using the Regular Copy Basic Features screen, see "Job Build(p.4-43)."
Remark
The 2-Sided Original mode is available only if the
optional Feeder (DADF-U1) is attached
(standard-equipped for the iR3245N/iR3235N/
iR3225N).
You cannot change the copy settings while the
machine is scanning originals in the Job Build mode.
You need to set the necessary copy settings
beforehand, according to the type of originals and the
desired result.
If you place the originals in the feeder, remove each
original from the original output area when scanning is
complete.
When copying, you can change or specify the following
settings before scanning the next batch of originals
(i.e., between batches): the number of copies, 2-Sided
Original mode, original type, copy exposure. However,
if you specify the Image Combination mode with the
Job Build mode, you cannot change the original type
and copy exposure.
If you use the Job Block Combination mode, the Job
Build mode is automatically set for each batch of
originals. You cannot use the Job Build mode for the
combined document.
1. Press [Scan Originals] → [Job Build].
2. Press [Set].
Acesst 1.0 6251194

Canon iR3225 Specifications

General

Print Technology	Laser
Copy Resolution	600 x 600 dpi
Monthly Duty Cycle	50, 000 pages
Paper Output	250 Sheets
Duplex Printing	Yes
Print Speed	25 ppm
Print Resolution	1200 x 1200 dpi
Copy Speed	25 cpm
Scan Resolution	600 x 600 dpi
Paper Capacity	550 sheets
Connectivity	USB, Ethernet
Warm-up Time	Less than 30 seconds
Paper Input (Standard)	550 sheets
Media Sizes	A4, A5, B5, Legal, Letter, Executive
Zoom	25-400%
Functions	Print, Copy, Scan
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac