7
Using the Express Copy Basic Features Screen
7-42 Recalling a Previous Copy Setting (Recall)
Recalling a Previous Copy Setting (Recall)
For instructions on this procedure using the Regular Copy Basic Features screen, see "Recalling
Previous Copy Jobs(p.5-2)."
Remark
One copy job is defined by setting the number of
copies, exposure, zoom, etc., and by pressing the
control panel power switch, or , when the Auto
Clear function is 'On', or by calling up a copy job stored
in memory. If one of these keys was not pressed, or if
the Auto Clear function is not active, calling up a copy
job by pressing [Recall] is not possible.
You cannot recall the Job Block Combination mode.
The Standard mode cannot be recalled or stored.
Identical copy modes that are stored, are counted as
one setting.
Even if a remote copy printer is stored in Recall mode,
and the main power of this machine or the remote copy
printer is turned OFF and ON again, the stored settings
change to standard Local Print settings. To use the
stored remote copy printer, confirm that the remote
copy printer is ON, update the remote copy printer
information after the specified time period you set in
Startup Time Settings in Network Settings in System
Settings (from the Additional Functions screen), and set
the Recall mode. (See the Network Guide or
"Specifying the Remote Copy Printer Settings(p.8-20).")
1. Press [Recall].
Acesst 1.0 6251194
To Next Page
Loading...
Need help?
General
