Canon iR3225 Guide

1
Introduction to the Copy Functions
1-40 Using the Stack Bypass
Using the Stack Bypass
You can perform reserved copying from the stack bypass by specifying in advance the paper to be
loaded for the next job. However, this is possible only if paper is being fed from the stack bypass for
the current job.
The following example assumes that A3 plain paper is being fed from the stack bypass for the current
job, and that you are selecting A4 plain paper to be fed from the stack bypass for a reserved job.
Remark
When printing on special types of paper, such as
heavy paper or transparencies, be sure to correctly set
the paper type, especially if you are using heavy paper.
If the type of paper is not set correctly, it could
adversely affect the quality of the image. Moreover, the
fixing unit may become dirty, or the paper could jam,
and a service repair may be needed.
If Stack Bypass Standard Settings in Common Settings
(from the Additional Functions screen) is set to 'On',
reserved copying can be performed only for the
registered paper size and type. (See the Reference
Guide.)
For more information on paper types, see the
Reference Guide.
Acesst 1.0 6251194

Canon iR3225 Specifications

General

Print Technology	Laser
Copy Resolution	600 x 600 dpi
Monthly Duty Cycle	50, 000 pages
Paper Output	250 Sheets
Duplex Printing	Yes
Print Speed	25 ppm
Print Resolution	1200 x 1200 dpi
Copy Speed	25 cpm
Scan Resolution	600 x 600 dpi
Paper Capacity	550 sheets
Connectivity	USB, Ethernet
Warm-up Time	Less than 30 seconds
Paper Input (Standard)	550 sheets
Media Sizes	A4, A5, B5, Legal, Letter, Executive
Zoom	25-400%
Functions	Print, Copy, Scan
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac