Error Codes
Overview
This section describes codes shown in case any problem is occurred.
Code type Description Reference
Error code Shown for any problem occurred in the device. List of error codes
Jam code This code is displayed when a jam occurs inside the machine. List of jam codes
Alarm code This code is displayed when the machine's function has been partially lost. List of jam codes
Error Codes
E Code Detail
Code
Item Description
E000 0000 Title Error in temperature rising of Fixing Assembly
Detection de-
scription
Temperature of the Fixing Assembly did not reach a certain temperature within the specified
period of time.
Remedy 1. Check the connection of connectors between the Fixing Assembly and the Engine Con-
troller PCB.
2.If the connector at the Fixing Assembly side does not have induction while the assembly
is removed, replace the assembly.
3. Replace the Engine Controller PCB.
E001 0000 Title Abnormal high temperature of Fixing Assembly
Detection de-
scription
It was detected that the temperature of the Fixing Assembly was abnormally high.
Remedy 1. Check the connection of connectors between the Fixing Assembly and the Engine Con-
troller PCB.
2. If the connector at the Fixing Assembly side does not have induction while the assembly
is removed, replace the assembly.
3. Replace the Engine Controller PCB.
E003 0000 Title Abnormal low temperature of Fixing Assembly
Detection de-
scription
After Heater turns on, Main Thermistor detected a temperature of 120 deg C or lower for
more than 20 seconds.
Remedy 1. Check the connection of connectors between the Fixing Assembly and the Engine Con-
troller PCB.
2. If the connector at the Fixing Assembly side does not have induction while the assembly
is removed, replace the assembly.
3. Replace the Engine Controller PCB.
E004 0000 Title Error in fixing power supply drive circuit
Detection de-
scription
Error in either the Fixing Heater or the Main Motor
Remedy 1. Check the connection of connectors between the Fixing Assembly and the Engine Con-
troller PCB.
2. If the connector at the Fixing Assembly side does not have induction while the assembly
is removed, replace the assembly.
3. Reconnect the connector on the Main Motor.
4. Replace the Main Motor.
5. Replace the Engine Controller PCB.
E100 0000 Title Laser Scanner error
Detection de-
scription
Error is detected in the Laser Scanner or the Scanner Motor.
Remedy 1. Reconnect the connector on Laser Scanner Unit.
2. Replace the Laser Scanner Unit.
E110 0000 Title Laser Scanner error
6. Error/Jam/Alarm
123
To Next Page
Loading...
Need help?
General