E-RDS Setup
■ Confirmation and preparation in advance
To monitor this machine with e-Maintenance/ imageWARE Remote, the following settings are required.
● Advance preparations
The following network-related information needs to be obtained from the user's system administrator in advance.
Information item 1
IP address settings
• Automatic setting : DHCP
• Manual setting : IP address, subnet mask and gateway address to be set
Information item 2
Is there a DNS server in use?
If there is a DNS server in use, find out the following.
• Primary DNS server address
• Secondary DNS server address
Information item 3
Is there a proxy server?
If there is a proxy server in use, find out the following.
• Proxy server address
• Port No. for proxy server
Information item 4
Is proxy server authentication required?
If proxy server authentication is required, find out the following.
• User name and password required for proxy authentication
● Network settings
Based on the results of the information obtained in "Advance preparations", make this machine network related settings.
See Users' Guide for detailed procedures.
CAUTION:
When changes are made to the above-mentioned network settings, be sure to turn OFF and then ON the main power of
this machine.
■ Steps to E-RDS settings
1. Start [SERVICE MODE].
2. Select [COPIER] > [FUNCTION] > [CLEAR] > [ERDS-DAT] and touch the [Yes].
NOTE:
This operation initializes the E-RDS settings to factory setting values.
For the setting values to be initialized, see the section of “Initialization procedure” on page 36.
3. Select [COPIER] > [FUNCTION] > [INSTALL] > [ERDS].
2. Technology
35
To Next Page
Loading...
Need help?
General