COPIER > COUNTER >
Item Description
Default value 0
TESTMODE
■ PRINT
TESTMODE> PRINT
Item Description
START
Title Output of test print
Details To output a test print with the PG pattern set in PG-TYPE, MODE, etc.
Use case At trouble analysis
Adj/set/operate method Enter the setting value, and then press Apply key.
PG-TYPE
Title Setting of PG number
Details To set the PG number of the test print.
Use case At trouble analysis
Adj/set/operate method Enter the setting value, and then press Apply key.
Display/adj/set range 0: Grid Bk
1: HT
2. Solid black
3: Solid white
4: 17 gradations
5: Thin horizontal line
6: Pascal correction chart
7: Chart128
Default value 0
COUNT
Title Setting of PG output quantity
Details To set the number of sheets for PG output.
Use case At trouble analysis
Adj/set/operate method Enter the setting value, and then press Apply key.
Display/adj/set range 1 to 99
Measure 1 sheet
Default value 1
PHASE
Title Setting of PG 2-sided mode
Details To set 1-sided/2-sided print for PG output.
Even if 2-sided print is set for a machine that only supports 1-sided print, the setting is disabled.
Use case At trouble analysis
Adj/set/operate method Enter the setting value, and then press Apply key.
Display/adj/set range 0 to 1
0 : 1-sided
1 : 2-sided
Default value 0
MODE
Title Setting of test print image formation method
Details To set the image formation method for the test print.
If PG-TYPE is 0/1, this setting is disabled because a specific image formation method is applied.
Use case At trouble analysis
Adj/set/operate method Enter the setting value, and then press Apply key.
7. Service Mode
151
To Next Page
Loading...
Need help?
General