Using the Caller ID Service to Reject Calls
If you subscribe to the Caller ID service, the machine detects the sender's Caller ID. If the sender's ID
matches the condition specified in this setting, the machine rejects the phone call or fax reception from the
sender.
Note
• This setting may not be supported depending on the country or region of purchase.
Contact your telephone company to confirm whether it provides this service.
Specify the setting following the procedure below.
1.
Make sure that the machine is turned on.
2.
Press the Setup button.
The Setup menu screen is displayed.
3.
Use the button to select Fax settings, then press the OK button.
4.
Use the button to select Security control, then press the OK button.
5.
Use the button to select Caller rejection, then press the OK button.
6.
Use the button to select Subscribed, then press the OK button.
You can now perform settings for Caller rejection.
7.
Use the button to select whether to reject a phone call or fax reception from an
anonymous number, then press the OK button.
8.
Use the button to select whether to reject a phone call or fax reception out of the
subscribed service area, then press the OK button.
9. Use the button to select whether to reject a phone call or fax reception from the
specified numbers, then press the OK button.
If you select Reject, you can register the fax/telephone number to reject.
When Register rejected no.? is displayed on the LCD, use the button to select Yes, then register
the fax/telephone number to reject.
For details on how to register the rejected number, see Registering the Rejected Number.
Note
•
Even if you select Reject, the machine rings once.
(The machine may not ring depending on the country or region of purchase.)
496
To Next Page
Loading...
Need help?
General
