116
Recording Still Images on a Memory Card
You can record still images with the camcorder, from a tape in the camcorder. You can also record a still
image on the memory card while you record a movie on the tape.
1. Turn the POWER dial to a recording program and move the TAPE/CARD switch to .
2. Press the PHOTO button halfway.
• The symbol turns green once the focus is adjusted. The picture may appear out
of focus for a moment while the camcorder is focusing.
• While the PHOTO button is half-pressed you can also use the focusing ring to adjust
the focus.
• Exposure is locked.
• When you press the PHOTO button on the wireless controller, recording starts
immediately.
3. Press the PHOTO button fully.
• The symbol disappears.
• The CARD access indicator flashes and the card access display appears.
Do not turn off the camcorder, change the position of the TAPE/CARD switch or the POWER dial,
open the memory card cover or remove the memory card while the CARD access indicator is
flashing. Doing so could result in data damage.
When you are using an SD Memory Card, make sure that the protect switch is set to allow
recording.
TAPE/CARD switch
PHOTO button
Card access indicator
To Next Page
Loading...
Need help?
General
