119
E
Using a Memory Card
Selecting the Drive Mode
Changing the Drive Mode
1. Set the POWER dial to a recording program other than and move the TAPE/CARD
switch to .
2. Press the DRIVE MODE button to switch between the drive modes.
The setting changes with each press of the button.
Continuous Shooting/High-Speed Continuous Shooting
Press and hold the PHOTO button.
A series of still images will be recorded as long as you hold the PHOTO button pressed down.
Maximum number of continuous shots at one time:
These figures are approximate and vary with the recording conditions and subjects.
Sufficient space on the memory card is required. Continuous shooting stops when card is full.
Continuous Shooting Captures a quick series of still images while you hold the PHOTO button
pressed down. For the number of frames per second, refer to the table
below.
High-Speed Continuous
AEB
(Auto Exposure Bracketing)
The camcorder records a still image in three different exposures (dark,
normal, light in 1/2 EV steps).
Single Records a single still image when you press the PHOTO button.
Still Image Size
Frames per Second Maximum Number of
Continuous Shots
Normal speed High speed
LW 1920 x 1080 3 frames 5 frames 30 images
SW 848 x 480 3 frames 5 frames 60 images
L 1440 x 1080 3 frames 5 frames 30 images
S 640 x 480 3 frames 5 frames 60 images
PHOTO button
DRIVE MODE
button
To Next Page
Loading...
Need help?
General
