100
English
If Manual [MAN] is selected, the inputs must be selected manually via the remote control using the " " or " " button.
By default this function is deactivated.
To change the Input Select function from Manual to Auto or contrary, proceed as follows:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item Input Select [SEL] and confirm with the "OK" button.
4
Change the setting using the "+" or "–" button and confirm with the "OK" button.
5
Press the "M" button to exit this menu item.
Notes: • The input [NET] is always selected automatically in case of an incoming audio signal!
• If you want the HDMI® inputs to be switched automatically too, please activate the CEC function.
• To automatically switch from the optical or coaxial digital input to one of the other inputs, the source unit must be switched off.
For analog Line and Bluetooth® stopping playback is sufficient.
Sub Output [OUT]
The Soundbar 10 has a build-in subwoofer. Therefore the function Sub Output [OUT] is deactivated ([OFF]) by default. To expand the frequency ran-
ge and to enhance low level frequency reproduction the Soundbar 10 can be extended with an external subwoofer. You can integrate an additional
subwoofer in the following ways:
• Connecting an active subwoofer using a RCA cable: If you set the function "Sub Out" to wired [WRD], you can connect your active subwoofer
to the SUB OUT on the rear of the Soundbar 10 using a cinch-RCA-cable. In this case the internal subwoofer of the Soundbar will automatically be
limitied to 80Hz and frequencies below 80Hz will be routed to the external subwoofer.
• Pairing a wireless subwoofer from Canton Smart-series: The Soundbar 10 has a build-in wireless transmitter that can stream audio and control
commands wirelessly from the Soundbar to paired wireless speakers and/or subwoofers from the Canton Smart-series within your room.
In case you have paired a wireless subwoofer in the menu "Wireless Setup [WIS] / Speaker Pairing [WSP]", the option "Wireless [WLS]" will
additionaly be available in the "Sub Output" menu. This means, that the connected subwofer gets the audio as well as the control commands
(state, volume, etc.) wirelessly.
• Connecting a wireless subwoofer from the Canton Smart-series using a signal cable: As an alternative to the wireless audio transmission, you can
connect
your subwoofer with a signal cable, so that the audio data is transmitted over the RCA cable and the control commands are transmitted wi
relessly. This way, the Smart subwoofer can be used like a "normal" subwoofer, but will still be controlled and adjusted by the Soundbar 10.
To do so, please set the option to "Wireless [WLS]" after you have successfully paired a Smart subwoofer according to chapter "Wireless Spea-
ker Pairing [WSP]".
To Next Page
Loading...
Need help?
General
Weight and Dimensions
