110
English
To change the way in which the paring process is initiated please proceed as follows:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate to the menu Wireless Setup [WIS] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item Bluetooth Setup [BT] and confirm with the "OK" button.
4
Select the menu item Pair Mode [BTP] and confirm with the "OK" button.
5
Select the desired parameter [MAN] resp. [AUT] using the "+" or "–" button, then press the"OK" button, again.
[AUT] = The device permanentely sends pairing requests (Auto mode).
[MAN] = The pairing process is activated by pressing the "BT Pairing" button on the remote.
6
Press the "M" button to exit this menu item.
Notes: • If a signal is being transmitted via Bluetooth® wireless technology, the Soundbar 10 does not send a pairing request to a second
(mobile) device, even if the automatic mode Auto [AUT] is selected.
• If the input Bluetooth is not selected, neither automatic nor manual pairing is possible. To achieve pairing independent of the
selected input, the BT Select [BTS] function must be set to automatic (please refer to the next chapter).
• Please find the requirements for a successful pairing in the chapter "Playback via Bluetooth® wireless technology".
BT Select [BTS]
When this function is set to Auto [AUT], the Soundbar 10 automatically switches to the BT input whenever it detects an audio signal from the
(mobile) device. If this function is deactivated and set to Manual [MAN], the input must be selected manually.
To activate / deactivate this function please proceed as follows:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate to the menu Wireless Setup [WIS] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item Bluetooth Setup [BT] and confirm with the "OK" button.
4
Use the " " or " " button to select the menu item BT Select [BTS] and confirm with the "OK" button.
5
Select the wanted parameter [MAN] resp. [AUT] using the "+" or "–" button.
6
Press the "M" button to exit this menu item.
Notes: • Depending on the (mobile) device used, with this function set to Auto [AUT] the Soundbar may also switch to the BT input when
typing a message or when other system tones occur. A time delay of 5 seconds is programmed to avoid continuous switching
(e.g. on arrival of a message).
• If the BT Select function is activated [AUT], the BT input cannot be selected via the input buttons " " or " " any longer.
• If the function "BT Select" is activated [AUT], the Soundbar 10 can be paired with a (mobile) device at any time, regardless of the
selected signal input.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
