96
English
8
If you do not want to assign a button to input BDP [HD1], you can select the desired input by pressing the " " button.
The " " button takes you to the previous input.
9
If you do not press any button on the TV-/universal-remote control within 15 seconds, the system returns to the IR Menu.
10
The BT input is the last entry in the list. By pressing the " " button again, the system jumps back to the IR menu.
Note: Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the Soundbar 10.
Signals from radio frequency (RF) remote controls cannot be learned, generally!
IR Clear [CLR]
Use this function to delete all learned IR codes stored on the Soundbar 10.
To delete the IR commands learned by the Soundbar 10, please do the following:
1
To enter the Menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the " " or " " button to select the IR Menu [IRM] and confirm with the "OK" button.
4
Choose the function IR Clear [CLR] and press the "OK" button. The OSD shows the IR Clear menu and "No" is selected. The display indica-
tes [NO].
5
To cancel the operation, press the "M" button or press the "OK" button.
6
To delete stored codes please use the " " button to select "Reset All", the display shows [YES]. Please press the "OK" button to delete the
codes.
7
The screen will display "Please Wait" for 3 seconds. The system will then return to the IR menu. The display confirmes the deletion by sho-
wing [CLR].
CEC [CEC]
Consumer Electronics Control is a cross-market standardized protocol for controlling devices connected to the HDMI® inputs/outputs. The device is
supplied with this function activated [ON].
The CEC functions supported by the Smart Soundbar 10 are:
- One touch Play: By pressing the “Play” button of the Blu-Ray player the Soundbar switches on automatically and changes to the
corresponding HDMI® input.
- System Standby: With the TV switched on, when you return it to standby mode by pressing the “Power” key the Soundbar 10 also goes
automatically into standby mode.
Note: Depending on the programming of the TV device, the Soundbar 10 can also be automatically activated with the TV.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
