3
91
English
To set the subwoofer’s phase to 180 degree resp. back to 0 degree, please do the following:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu Speaker Setup [SPS] and confirm with the "OK" button.
3
Use the " " or " " button to navigate into the menu Subwoofer Setup [SUB] and confirm with the "OK" button.
4
Use the " " or " " button select the menu item Sub Phase [PHA] and confirm with the "OK" button.
5
Change the setting using the "+" or "–" key between 0 degrees [0] and 180 degree [180] and confirm with the "OK" button.
6
To exit the menu, press the Menu button "M".
Sub Stereo [SSM]
If you are using Canton Smart large speakers you can select the Sub Stereo Mode "Parallel" to have the full music signal (including the bass) rou-
ted to the front speakers (FL, FR) and have the bass routed additionally to the (connected) subwoofer in the playmode Stereo.
In the Sub Stereo Mode "Xover" you can split the signal between the (connected) subwoofer and the large front speakers using a crossover.
The crossover frequency can be adjusted in the menu item Stereo Sub Xover [SSX] in values between 40 Hz and 100 Hz. This function is only
available if Canton Smart large speakers are paired as front speakers (FL, FR) and a Canton Smart subwoofer is paired resp. if the Sub Out [OUT]
is activated in System Setup [SYS]. This function is set to Off [OFF] as factory setting.
To activate or change the Sub Stereo Mode please do as follows:
1
To enter the menu, press the "M" button.
2
Confirm the first menu item Speaker Setup [SPS] with the "OK" button.
3
Use the " " or " " button to select the menu item Subwoofer Setup [SUB] and confirm with the "OK" button.
4
Use the " " or " " button to select the menu item Sub Stereo Mode [SSM] and confirm with the "OK" button.
5
Use the "+" resp. the "–" key to select the desired function:
Off [OFF] means that the bass signals are played through the front speakers FL / FR.
Parallel [PAR] means that the subwoofer plays the bass signals additionally to the front speakers
Xover [XOV] means that the bass signals below the set crossover frequency Stereo Sub Xover are played through the subwoofer
6
Confirm and exit the menu item by pressing the "M" button.
Stereo Sub Xover [SSX]
With this menu item you can set the frequency at which the audio signal is split into the signal for the subwoofer and the signal for the front
speakers in the Sub Stereo Mode "Xover". This menu item is only available if the Sub Stereo Mode is set to "Xover".
To Next Page
Loading...
Need help?
General
Weight and Dimensions
