4
669224-R5
NSTALLATION
I
2.3 Installation Procedure
Follow the steps shown to install the attachment on the truck.
Read and understand WARNING and CAUTION statements.
If you don't understand a procedure, ask your supervisor or
call the nearest Cascade Service Department for assistance.
CL0442.ai
1
2
Attach overhead hoist
A Remove banding, use multiple chains to
stabilize the attachment while lifting. Set the
attachment upright on the pallet.
B If equipped, remove bolt-on lower mounting
hooks.
Unlock quick-change lower
mounting hooks
A Remove pin and drop hooks into unlocked
position.
B Reinstall pin in lower hole.
WARNING: Check the attachment
weight (located on the nameplate)
to make sure the overhead hoist
and chains or straps are at least the
rated capacity of the attachment.
A
B
cascade
®
C-675514-1
CL0097.eps
A
B
Guide
Pin
LH Lower
Hook
5/8 in. (16 mm)
offset on top
provides maximum
hook clearance.
Tighten capscrews to:
CL II/III – 110 ft.-lbs. (150 Nm)
CL IV – 190 ft.-lbs. (260 Nm)
NOTE: Guides can be reversed
to change hook-to-carriage
clearance. Refer to lower hook
installation, Step 6.
To Next Page
Loading...
Need help?
General
