TUTORIAL: GETTING TO KNOW YOUR CISCO DIGITAL MEDIA ENCODER 2000
NOTE: For security purposes, the password for your account will not be displayed once it has been
entered into the Cisco Digital Media Encoder 2000 settings. However, although this field appears
blank after you click the Submit button, the password information has been retained.
NOTE: If you change any information in this dialogue box, you will need to re-enter your SMTP
password before clicking the Submit button. Not doing so will overwrite the previously entered
password with a blank entry.
Once you have entered the information above, click the Submit button to save your changes. Please
see the screenshot directly below.
You can test your settings by clicking the Send Test Email link. The resulting page will report if the
email was successfully sent or there was a send failure.
Idle Screen Information
This section allows you to modify the information displayed in the Cisco Digital Media Encoder
2000 LCD display on its front panel.
Check the boxes next to the information you wish to be displayed. This information is cycled as the
LCD display alternates between status information and encoder information.
At the top of the LCD idle screen is the default message the Cisco Digital Media Encoder 2000 is
Ready. You can customize this message.
Cisco Digital Media Encoder 2000 User Guide 68
To Next Page
Loading...
Need help?
General
