Cisco 3750G-12S - Catalyst Switch - Stackable User Manual

D-5
Catalyst 3750 Switch Hardware Installation Guide
OL-6336-09
Appendix D Configuring the Switch with the CLI-Based Setup Program
Connecting to the Console Port
Connecting to the Console Port
You can use the console port to perform the initial configuration. To connect the switch console port to
a PC, use the supplied RJ-45-to-DB-9 adapter cable.
Note If you have stacked your switches, connect to the console port of one of the switches in the stack. The
initial configuration for the entire stack can be performed on any switch in the stack.
Follow these steps to connect the PC or terminal to the switch:
Step 1 Using the supplied RJ-45-to-DB-9 adapter cable, insert the RJ-45 connector into the console port on the
rear of a switch, as shown in Figure D-4.
Step 2 Attach the DB-9 female DTE of the adapter cable to a PC serial port, or attach an appropriate adapter to
the terminal.
Figure D-4 Connecting a Switch to a PC
1 Catalyst 3750 switches 3 RJ-45-to-DB-9 adapter cable
2 Power cord
RATING
100-200V ~
1.6A-0>9A, 50-60 HZ
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+12v @
8.5a
CONSOLE
RATING
100-200V ~
1.6A-0>9A, 50-60 HZ
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+12v @8 .5a
CONSOLE
RATING
100-200V ~
1.6A-0>9A, 50-60 HZ
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+12v @
8.5a
CONSOLE
1
2
3
90531

Cisco 3750G-12S - Catalyst Switch - Stackable Specifications

General

Brand	Cisco
Model	3750G-12S - Catalyst Switch - Stackable
Category	Switch
Language	English