Cisco 3750G-12S - Catalyst Switch - Stackable User Manual

2-45
Catalyst 3750 Switch Hardware Installation Guide
OL-6336-10
Chapter 2 Switch Installation
Where to Go Next
Figure 2-58 Connecting to a XENPAK Module Port
Step 6 If necessary, reconfigure and restart the switch or target device.
Where to Go Next
If the default configuration is satisfactory, the switch needs no further configuration. You can use any of
these management options to change the default configuration:
• Start the device manager, which is in the switch memory, to manage individual and standalone
switches. This is an easy-to-use web interface that offers quick configuration and monitoring.
You can access the device manager from anywhere in your network through a web browser.
For more information, see the device manager online help.
• Start the Network Assistant application, which is described in the Getting Started with Cisco
Network Assistant guide. Through this GUI, you can configure and monitor a switch cluster or an
individual switch.
• Use the CLI to configure the switch as a member of a cluster or as an individual switch from the
console. See the Catalyst 3750 Switch Command Reference on Cisco.com for information on using
the CLI with a Catalyst 3750 switch.
• Start an SNMP application such as the CiscoView application.
1 SC connector
Catalyst 3750
series
104575
1
TX
RX
1

Cisco 3750G-12S - Catalyst Switch - Stackable Specifications

General

Brand	Cisco
Model	3750G-12S - Catalyst Switch - Stackable
Category	Switch
Language	English