Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Guide

Chapter 15 Configuring the 4GE SSM for Fiber
Cabling 4GE SSM Interfaces
15-2
Cisco ASA 5500 Series Getting Started Guide
78-19186-01
Cabling 4GE SSM Interfaces
To cable 4GE SSM interfaces, perform the following steps for each port you want
to connect to a network device:
Step 1 To connect an RJ-45 (Ethernet) interface to a network device, perform the
following steps for each interface:
a. Locate a yellow Ethernet cable from the accessory kit.
b. Connect one end of the cable to an Ethernet port on the 4GE SSM as shown
in
Figure 15-1.
Figure 15-1 Connecting the Ethernet port
c. Connect the other end of the cable to your network device.
Step 2 (Optional) If you want to use an SFP (fiber optic) port, install and cable the SFP
modules as shown in
Figure 15-2:
a. Insert and slide the SFP module into the SFP port until you hear a click. The
click indicates that the SFP module is locked into the port.
b. Remove the optical port plugs from the installed SFP.
c. Locate the LC connector (fiber optic cable) in the 4GE SSM accessory kit.
d. Connect the LC connector to the SFP port.
1 RJ-45 (Ethernet) port
143597
MGMT
USB2
Cisco SSM-4GE
LNK
SPD
0
1
2
3
POWER
STATUS
MGMT
USB2
USB1
Cisco SSM-4GE
1

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English