Cisco 7945G Administration Guide

2-9
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17755-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones to the Cisco Unified Communications Manager Database
Table 2-5 provides an overview of these methods for adding phones to the Cisco Unified
Communications Manager database.
Adding Phones with Auto-Registration
By enabling auto-registration before you begin installing phones, you can:
• Add phones without first gathering MAC addresses from the phones.
• Automatically add a Cisco Unified IP Phone to the Cisco Unified Communications Manager
database when you physically connect the phone to your IP telephony network. During
auto-registration, Cisco
Unified Communications Manager assigns the next available sequential
directory number to the phone.
• Quickly enter phones into the Cisco Unified Communications Manager database and modify any
settings, such as the directory numbers, from Cisco
Unified Communications Manager.
• Move auto-registered phones to new locations and assign them to different device pools without
affecting their directory numbers.
Note Cisco recommends you use auto-registration to add less than 100 phones to your network. To add more
than 100 phones to your network, use the Bulk Administration Tool (BAT). See the
“Adding Phones with
BAT” section on page 2-11.
Auto-registration is disabled by default. In some cases, you might not want to use auto-registration; for
example, if you want to assign a specific directory number to the phone, or if you plan to implement
authentication or encryption, as described in Cisco Unified Communications Manager Security Guide.
For information about enabling auto-registration, refer to “Enabling Auto-Registration” in the Cisco
Unified
Communications Manager Administration Guide.
Ta b l e 2-5 Methods for Adding Phones to the Cisco Unified Communications Manager
Database
Method
Requires MAC
Address?
Notes
Auto-registration No • Provides no control over directory number
assignment to phone.
• Not available when security or encryption is
enabled.
Auto-registration with TAPS No Requires auto-registration and the Bulk
Administration Tool (BAT); updates the Cisco
Unified
Communications Manager database with
the MAC address and DNs for the device when
user calls TAPS from the phone.
Using the Cisco Unified
Communications Manager
Administration
Yes Requires phones to be added individually
Using BAT Yes Can add groups of same model of phone.
Can schedule when phones are added to the Cisco
Unified Communications Manager database.

Cisco 7945G Specifications

General

Brand	Cisco
Model	7945G
Category	IP Phone
Language	English