Cisco 7945G Administration Guide

8-8
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17755-01
Chapter 8 Monitoring the Cisco Unified IP Phone Remotely
Network Statistics
Network Statistics
These network statistics areas on a phone’s web page provide information about network traffic on the
phone:
• Ethernet Information area—Displays information about Ethernet traffic. Table 8-3 describes the
items in this area.
• Access area—Displays information about network traffic to and from the PC port on the phone.
Table 8-4 describes the items in this area.
• Network area—Displays information about network traffic to and from the network port on the
phone.
Table 8-4 describes the items in this area.
Auto Line Select Indicates whether the phone shifts the call focus to incoming calls on all lines.
DSCP for Call Control DSCP IP classification for call control signaling.
DSCP for
Configuration
DSCP IP classification for any phone configuration transfer.
DSCP for Services DSCP IP classification for phone-based services.
Security Mode Displays the security mode that is set for the phone.
Web Access Enabled Indicates whether web access is enabled (Yes) or disabled (No) for the phone.
Span to PC Port Indicates whether the phone will forward packets transmitted and received on
the network port to the access port.
PC VLAN VLAN used to identify and remove 802.1P/Q tags from packets sent to the
PC.
Forwarding Delay Indicates whether the internal switch begins forwarding packets between the
PC port and switched port on the phone when the phone becomes active.
CDP: PC Port Indicates whether CDP is supported on the PC port.
CDP: SW Port Indicates whether CDP is supported on the switch port.
LLDP-MED: SW Port Indicates whether Link Layer Discovery Protocol Media Endpoint Discovery
(LLDP-MED) is enabled on the switch port.
LLDP: PC Port Indicates whether Link Layer Discovery Protocol (LLDP) is enabled on the
PC port.
LLDP Power Priority Advertises the phone’s power priority to the switch, enabling the switch to
appropriately provide power to the phones. Settings include:
• Unknown—default
• Low
• High
• Critical
LLDP Asset ID Identifies the asset ID assigned to the phone for inventory management.
Table 8-2 Network Configuration Area Items (continued)
Item Description

Cisco 7945G Specifications

General

Brand	Cisco
Model	7945G
Category	IP Phone
Language	English