Chassis ID TLV
For the outgoing LLDPDU, the TLV supports subtype=5 (Network Address). When the IP address is known,
the value of the Chassis ID is an octet of the INAN address family number followed by the octet string for
the IPv4 address used for voice communication. If the IP address is unknown, the value for the Chassis ID is
0.0.0.0. The only INAN address family supported is IPv4. Currently, the IPv6 address for the Chassis ID is
not supported.
For the incoming LLDPDU, the Chassis ID is treated as an opaque value to form the MSAP identifier. The
value is not validated against its subtype.
The Chassis ID TLV is mandatory as the first TLV. Only one Chassis ID TLV is allowed for the outgoing
and incoming LLDPDUs.
Port ID TLV
For the outgoing LLDPDU, the TLV supports subtype=3 (MAC address). The 6 octet MAC address for the
Ethernet port is used for the value of Port ID.
For the incoming LLDPDU, the Port ID TLV is treated as an opaque value to form the MSAP identifier. The
value is not validated against its subtype.
The Port ID TLV is mandatory as the second TLV. Only one Port ID TLV is allowed for the outgoing and
incoming LLDPDUs.
Time to Live TLV
For the outgoing LLDPDU, the Time to Live TTL value is 180 seconds. This differs from the 120-second
value that the standard recommends. For the shutdown LLDPDU, the TTL value is always 0.
The Time to Live TLV is mandatory as the third TLV. Only one Time to Live TLV is allowed for the outgoing
and incoming LLDPDUs.
End of LLDPDU TLV
The value is 2-octet, all zero. This TLV is mandatory and only one is allowed for the outgoing and incoming
LLDPDUs.
Port Description TLV
For the outgoing LLDPDU, in the Port Description TLV, the value for the port description is the same as
“Port ID TLV” for CDP. The incoming LLDPDU, the Port Description TLV, is ignored and not validated.
Only one Port Description TLV is allowed for outgoing and incoming LLDPDUs.
System Name TLV
For the Cisco IP Phone, the value is SEP+MAC address.
Example: SEPAC44F211B1D0
The incoming LLDPDU, the System Name TLV, is ignored and not validated. Only one System Name TLV
is allowed for the outgoing and incoming LLDPDUs.
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
55
Cisco IP Phone Installation
Chassis ID TLV
To Next Page
Loading...
Need help?
General
