Cisco 8851 Administration Guide

Before you begin
Access the phone administration web page. See Access the Phone Web Page, on page 88.
Procedure
Step 1 Select Voice > Ext(n), where n is an extension number.
Step 2 Scroll to the Dial Plan section.
Step 3 Enter the digit sequences in the Dial Plan field.
The default (US-based) systemwide dial plan appears automatically in the field.
Step 4 You can delete digit sequences, add digit sequences, or replace the entire dial plan with a new dial plan.
Separate each digit sequence with a pipe character, and enclose the entire set of digit sequences within
parentheses. Example:
(9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx)
Step 5 Click Submit All Changes.
The phone reboots.
Step 6 Verify that you can successfully complete a call with each digit sequence that you entered in the dial plan.
If you hear a reorder (fast busy) tone, review your entries and modify the dial plan appropriately.
Note
Reset the Control Timers
If you need to edit a timer setting only for a particular digit sequence or type of call, you can edit the dial plan.
Before you begin
Access the phone administration web page. See Access the Phone Web Page, on page 88.
Procedure
Step 1 Select Voice > Regional.
Step 2 Scroll to the Control Timer Values (sec) section.
Step 3 Enter the desired values in the Interdigit Long Timer field and the Interdigit Short Timer field.
Step 4 Click Submit All Changes.
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
78
Cisco IP Phone Installation
Reset the Control Timers

Cisco 8851 Specifications

General

Brand	Cisco
Model	8851
Category	IP Phone
Language	English