Bandwidth (kbit/s)Rate
9,621,504STM-64
Restrictions for Scale PW Circuits
•
Only 1000 CEM PW Circuits per OCN Interface modules are supported.
Restrictions for SDH in CESoPSN
•
If the eighth port is configured as STM-64, you cannot use port 0 to port 7. Similarly, if any one port
(0-7) is configured for STM-1, STM-4 or STM-16, you cannot use the eighth port.
•
Ports 0 to 7 are divided in four groups, 0-1, 2-3, 4-5, and 6-7. If one port in the group is configured for
STM-16, you cannot use the other port.
• This IM does not support CEP on AU-4 — VC-4 — TUG-3 — VC-3.
•
This IM does not support CT3, CE3, CT3-E1 under the VC3 container. Only clear channel T3/E3 services
are supported.
•
This IM does not support the framed SAToP for T3/E3 and T1/E1 and CESoPSN.
•
Eight BERT engines are supported for Higher Order and 16 BERT engines are supported for Lower
Order hierarchy.
•
If a port is configured as SDH, all ports can only be configured as SDH unless the mode SDH is removed
from all the ports on the IM.
•
VC-4-64c and VC-2 are not supported.
•
AU-4 CT3, AU-4 CE3, AU-4 CT3-E1, AU-3-CT3, AU-3-CE3, and AU-3 CT3-E1 are not supported.
AU-4 — VC-4 — TUG-3 — VC-3 — DS3 — T1/E1, AU-4 — VC-4 — TUG-3 — VC-3 — E3 — E1,
AU-3 — VC-3 — DS3 — T1/E1, and AU-3 — VC-3 — E3 — E1 are not supported.
•
Concatenation VC-4-Nc is only supported for augment mapping AU-4.
•
E3 MDL is not supported.
Restrictions on Bandwidth
•
Total available bandwidth for 1-Port OC192/STM-64 or 8-Port OC3/12/48/STM-1/-4/-16 Module is
10G.
The following configuration is blocked and an error message is displayed after the maximum bandwidth
is utilized:
rate stm1 | rate stm4 | rate stm16 | stm64
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
87
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
Restrictions for SDH in CESoPSN
To Next Page
Loading...
Need help?
General
