Cisco ASR 900 Series Configuration Guide

Configuring Unidirectional APS for SAToP
To configure unidirectional ACR (SONET Framing), use the following commands:
enable
configure terminal
controller sonet 0/5/0
clock source internal
aps group acr 1
aps working 1
aps unidirectional
exit
controller sonet 0/5/0
aps group acr 1
aps protect 1 10.7.7.7
aps revert 3
aps adm
end
To restore the system to its default condition, use the no form of the command.Note
Configuring Bi-directional ACR (SONET Framing) for SAToP
To configure bi-directional ACR (SONET Framing), use the following commands:
enable
configure terminal
controller sonet 0/5/0
clock source internal
aps group acr 1
aps working 1
exit
controller sonet 0/4/0
aps group acr 1
aps protect 1 10.7.7.7
end
To restore the system to its default condition, use the no form of the command.Note
Verifying CEM Statistics for SAToP
Use the following commands to verify the pseudowire configuration for SAToP:
• show cem circuit—Displays information about the circuit state, administrative state, the CEM ID of
the circuit, and the interface on which it is configured. If cross connect is configured under the circuit,
the command output also includes information about the attachment circuit status.
Router# show cem circuit
<0-32000> CEM ID
detail Detailed information of cem ckt(s)
interface CEM Interface
summary Display summary of CEM ckts
| Output modifiers
Router# show cem circuit
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
6
Configuring CEM
Verifying CEM Statistics for SAToP

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English