Cisco ASR 900 Series Configuration Guide

• AU-3 — TUG-2 — VC-11 — T1
• AU-3 — TUG-2 — VC-12 — E1
• AU-3 — TUG-2 — VC-11
• AU-3 — TUG-2 — VC-12
• AU-3 — VC-3 — E3
Configuring AUG Mapping
This section describes the configuration of Administration Units Group (AUG) mapping.
Configuring AU-3 or AU-4 Mapping
To configure AU-3 or AU-4 mapping:
configure terminal
aug mapping [au-3 | au-4]
end
The aug mapping command is available only when SDH framing is configured.Note
The AUG mapping mode is AU-4 by default. AUG mapping is supported at STM-1 level.Note
Configuring Mixed AU-3 and AU-4 Mapping
To configure mixed AU-3 and AU-4 mapping:
configure terminal
aug mapping [au-3 | au-4] stm [1-1] stm1 number [1-4]
end
Use the following command to change the AUG mapping of a particular STM-1 to AU-3:
aug mapping au-3 stm [1-16] path number 1-16
After configuring this command for STM-4 the AUG mapping of path 2, 3, and 4 is AU-4 and for path 1
it is AU-3.
Note
Verifying AUG Mapping Configuration
Use show running-configuration command to verify the AUG mapping configuration.
show running-config | sec 0/3/4*Apr 20 03:51:28.151 PDT: %SYS-5-CONFIG_I: Configured from
console by console
platform enable
controller MediaType 0/3/4 oc12
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
77
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
Configuring AUG Mapping

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English