Cisco ASR 900 Series Configuration Guide

High transmit power alarm threshold = 4.0 dBm
High transmit power warning threshold = 2.0 dBm
Low transmit power warning threshold = -7.0 dBm
Low transmit power alarm threshold = -9.0 dBm
High receive power alarm threshold = 1.0 dBm
Low receive power alarm threshold = -26.0 dBm
High receive power warning threshold = -1.0 dBm
Low receive power warning threshold = -24.9 dBm
External Calibration: bias current slope = 1.000
External Calibration: bias current offset = 0
show hw-module subslot <slot/bay> transceiver <port> idprom brief:
sh hw-module subslot 0/7 transceiver 6 idprom brief
IDPROM for transceiver SPA-1T8S-10CS_7/6:
Description = SFP or SFP+ optics (type 3)
Transceiver Type: = ONS SE Z1 (406)
Product Identifier (PID) = ONS-SE-Z1
Vendor Revision = A
Serial Number (SN) = FNS19251NQ0
Vendor Name = CISCO-FINISAR
Vendor OUI (IEEE company ID) = 00.90.65 (36965)
CLEI code = WMOTCZPAAA
Cisco part number = 10-1971-04
Device State = Enabled.
Date code (yy/mm/dd) = 15/06/19
Connector type = LC.
Encoding = 8B10B
NRZ
Manchester
Nominal bitrate = OC48/STM16 (2500 Mbits/s)
Minimum bit rate as % of nominal bit rate = not specified
Maximum bit rate as % of nominal bit rate = not specified
Configuring BERT in Sonet for CESoPSN
Bit-Error Rate Testing (BERT) is used for analyzing quality and for problem resolution of digital transmission
equipment. BERT tests the quality of an interface by directly comparing a pseudorandom or repetitive test
pattern with an identical locally-generated test pattern.
The supported BERT patterns are 2^11, 2^15, 2^20-O153, and 2^20-QRSS.
BERT is supported in the following two directions:
• Line—Supports BERT in TDM direction.
• System—Supports BERT in PSN direction.
BERT is supported in following controllers:
• T1—NxDS0, DS1
• T3—NxDS0, DS1 (channelised), clear channel DS3.
• OCx—NxDS0, DS1 (channelised), DS3 (channelised), clear channel DS3, STS1, STS-nc, VT-1.5, VT1.5
T1
The following table shows the supported SONET level of BERT patterns.
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
53
Configuring SONET
Configuring BERT in Sonet for CESoPSN

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English