Cisco ASR 900 Series Configuration Guide

Configuring CEM Group for AU4-E1 on SDH for CESoPSN
To configure MediaType controller and rate on SDH port, use the following commands:
enable
configure terminal
controller mediatype 0/5/0
mode sdh
controller sdh 0/5/0
rate stm1
end
To configure CEM group for AU4-E1 on SDH for CESoPSN, use the following commands:
enable
configure terminal
controller sdh 0/5/0
aug mapping au-4
au-4 1
mode tug-3
tug-3 1
mode vc1x
Tug-2 1 payload vc12
e1 1 cem-group 0 timeslots 1 - 7
vc 1 overhead v5 2
end
Verifying CEM Group for AU4-E1 on SDH for CESoPSN
This section includes show command to verify CEM Group for AU4-E1 on SDH for CESoPSN:
Router# show cem circuit interface cem 0/5/0
sdh0/5/0, ID: 0, Line: UP, Admin: UP, Ckt: ACTIVE
Path Mode : VC1X,Payload:VC12, AU4: 1, TUG-3: 1, E1: 1,CEM Mode: sdh-CESoP
Controller state: up, T1/E1 state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 6 (In use: 0)
Payload Size: 56
Framing: Framed (DS0 channels: 1-7)
CEM Defects Set
None
Signalling: No CAS
RTP: No RTP
Ingress Pkts: 54113124 Dropped: 0
Egress Pkts: 54112259 Dropped: 0
CEM Counter Details
Input Errors: 0 Output Errors: 0
Pkts Missing: 868 Pkts Reordered: 0
Misorder Drops: 0 JitterBuf Underrun: 869
Error Sec: 0 Severly Errored Sec: 0
Unavailable Sec: 0 Failure Counts: 28
Pkts Malformed: 0 JitterBuf Overrun: 0
Generated Lbits: 0 Received Lbits: 0
Generated Rbits: 868 Received Rbits: 1830
Generated Mbits: 146392 Received Mbits: 232588
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
106
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
Configuring CEM Group for AU4-E1 on SDH for CESoPSN

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English