Cisco ASR 900 Series Configuration Guide

bidirectional, non-revertive
PGP timers (extended for HA): hello time=1; hold time=10
hello fail revert time=120
Received K1K2: 0x00 0x05
No Request (Null)
Transmitted K1K2: 0x00 0x00
No Request (Null)
Remote APS configuration: (null)
SONET 0/0/2 APS Group 25: working channel 1 (Active) (HA)
Protect at 1.1.1.1
PGP timers (from protect): hello time=1; hold time=10
Remote APS configuration: (null)
Configuring APS for CESoPSN
This section describes the configuration of APS for CESoPSN.
Configuring CEM Group for APS CT3-T1 in CESoPSN
To configure CEM group in CT3 mode of STS-1 for CESoPSN, use the following commands:
enable
configure terminal
controller sonet-acr 200
sts-1 1
mode ct3
t1 1 cem-group 0 timeslots 1 - 2
end
To configure internal clock source for the working controller, use the following commands:
enable
configure terminal
controller sonet 0/3/6
sts-1 3
t1 1 clock source internal
t1 1 framing esf
end
To configure internal clock source for the protect controller, use the following commands:
enable
configure terminal
controller sonet 0/4/6
sts-1 3
vtg 1 t1 1 clock source internal
vtg 1 t1 1 framing esf
end
Configuring CEM Group for APS VT1.5-T1 in CESoPSN
To configure CEM group in VT 1.5 mode of STS-1 for CESoPSN, use the following commands:
enable
configure terminal
controller sonet-acr 200
sts-1 3
mode vt-15
vtg 1 t1 1 cem-group 37 timeslots 1 - 5
end
To configure internal clock source for the working controller, use the following commands:
enable
configure terminal
controller sonet 0/3/6
sts-1 3
vtg 1 t1 1 clock source internal
vtg 1 t1 1 framing esf
end
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
43
Configuring SONET
Managing and Monitoring SONET Line

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English