Cisco Catalyst 9404R Switch User Manual

--Retainer strip strapped into place1
Verifying the Power Supply Installation
Procedure
Step 1 Verify the power supply operation by checking the power supply’s front-panel LEDs. You should see the
following:
• The INPUT LED is green.
• The OUTPUT LED is green if it is an active module and blinking green if it is a redundant module.
• The FAIL LED is off.
Step 2 Check the power supply and system status from the system console by entering show power command in
privileged EXEC mode.
Switch# show power
Step 3 If the LEDs or show power command output indicate a power problem or other system problem, see the
“Troubleshooting” section for more information.
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
103
Removing and Replacing FRUs
Verifying the Power Supply Installation

Cisco Catalyst 9404R Switch Specifications

General

Brand	Cisco
Model	Catalyst 9404R Switch
Category	Switch
Language	English