Cisco Catalyst 9404R Switch User Manual

Using the Add or Remove Programs Utility
Before you begin
Disconnect the switch console terminal before uninstalling the driver.
Procedure
Step 1 Click Start > Control Panel > Add or Remove Programs.
Step 2 Scroll to Cisco Virtual Com and click Remove.
Step 3 When the Program Maintenance window appears, select the Remove radio button. Click Next.
Uninstalling the Cisco Microsoft Windows Vista and Windows 7 USB Driver
Before you begin
Disconnect the switch console terminal before uninstalling the driver.
Procedure
Step 1 Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 2 The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 3 When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 4 When the Remove the Program window appears, click Remove.
If a User Account Control warning appears, click Allow - I trust this program to proceed.
Note
Step 5 When the InstallShield Wizard Completed window appears, click Finish.
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
160
Initial Configuration for the Switch
Using the Add or Remove Programs Utility

Cisco Catalyst 9404R Switch Specifications

General

Product Type	Modular Switch
Form Factor	Rack-mountable
Slot Capacity	4
Management	Cisco IOS XE
Model	Catalyst 9404R
Product Series	Catalyst 9400 Series
Uplink Ports	Varies by module
Downlink Ports	Varies by module
Supported Modules	C9400-LC-24XS, C9400-LC-48T, C9400-LC-48U
Power Supply	AC or DC
Power Supply Options	AC or DC
Redundancy	Power supply redundancy
Operating Temperature	0 to 40 °C
Storage Temperature	-40 to 70 °C
Relative Humidity	5% to 90% noncondensing