Verify DNCS System Configuration Settings
Verify DNCS System Configuration Settings
We recommend that you do not change the default DHCT and network signaling
parameters in the DSM-CC portion of the DNCS System Configuration window
when you stage DHCTs.
Note: For more information on the DNCS System Configuration window and the
recommended parameter settings for that window, refer to the Digital Network
Control System Online Help for your system release.
Verify Current DNCS System Configuration Settings (DAVIC Systems)
Verifying Current DNCS System Configuration Settings (DAVIC)
Follow these steps to verify your current DNCS system configuration settings.
1 From the Administrative Console on the DNCS, select System Provisioning.
2 In the System Management area of the DNCS Administrative Console, select
DHCT Mgr. The DHCT Manager window opens with the DHCT Manager
Modes tab in the forefront.
3 Is DHCT Registration set to Administrative Gateway?
If yes, go to step 4.
If no, change the DHCT Registration setting to Administrative Gateway,
then go to step 5.
4 Is IP Address Assignment set to Override?
If yes, go to step 5.
If no, change the IP Address Assignment setting to Override, then to go step
5.
5 Click Save. The system saves your settings and the DHCT Manager window
closes.
6 Go to Billing System Preparation (on page 20).
Verify Current DNCS System Configuration Settings (DOCSIS Systems)
If your system uses DOCSIS, refer to DOCSIS in a DBDS Environment (part number
4000358) to verify your DNCS system configuration.
To Next Page
Loading...
Need help?
General
